Effect of Pyrolysis Temperature and Feedstock Sources on Physicochemical Characteristics of Biochar

Document Type : Original Research

Authors
A. Reyhanitabar
E. Frahadi
H. Ramezanzadeh
S. Oustan
Department of Soil Science, Faculty of Agriculture, University of Tabriz, Tabriz, Islamic Republic of Iran.
Abstract
Converting feedstock into biochar is a popular approach to overcome the disposal problem, yet the role of waste type and pyrolysis temperature on biochar properties is not understood well. In this study, biochars were produced from various feedstock such as tea waste, apple wood, wheat straw and walnut shell at 300, 400, 500 and 600°C with 1-hour residence time. The results showed that increase in pyrolysis temperature significantly decreased biochar mass yield. The maximum and minimum mass yields were observed in walnut shell at 300˚C and apple-wood-derived biochars at 600˚C by 69 and 20%, respectively. The produced biochar had pH range between 5.3 to 9.7, and its pH value and ash content increased significantly with increasing pyrolysis temperature, except for walnut shell. Total concentrations of P, Ca, K, Na, Fe, Zn, Cu, and Mn and available concentrations of K, Ca, Mg, and P increased with pyrolysis temperature increasing in all samples, except at walnut shell-derived biochar. According to CHN analysis, by increasing pyrolysis temperature, the total carbon concentration increased but total nitrogen and hydrogen concentrations decreased. The pH value decreased with time until 72 hours, beyond which a near steady-state condition was attained. Relationships between pH and CaCO3-eq content of biochars were close and linear. The FT-IR spectra showed that aromatic C increased by increment in heating. Also, by increasing pyrolysis temperature, the mean pore diameter decreased but micropores volume increased and led to increase in the specific surface area of biochars. The results of this study suggest that biochars produced at 300 and 400˚C may have potential as fertilizer in calcareous soils because of low pH and EC, with high mass yield.

Keywords

Subjects

Amonette, J., and Joseph, S. 2009. Characteristics of Biochar: microchemical properties. In: Lehmann, J., Joseph, S. (Eds.), Biochar for Environmental Management: Science and Technology. Earthscan, London.
Antal Jr., M.J., and Gronli, M. 2003. The art, science, and technology of charcoal production. Industrial Engineering Chemistry Research, 42:1619-1640.
ASTM. 2007. D1762-84: Standard Methods for Chemical Analysis of Wool Charcoal. American Society for Testing and Materials international, West Conshohocken, PA, USA.
Beesley, L., Moreno-Jiménez, E., Gomez-Eyles, J. L., Harris, E., Robinson, B., and Sizmur, T. 2011. A review of biochars potential role in the remediation, revegetation and restoration of contaminated soils. Environmental Pollution, 159: 3269–3282.
Boehm, H. P. 2008. Surface chemical characterization of carbons from adsorption studies. In: BOTTANI, E.J.; TASCÓN, J.M.D. (Ed.). Adsorption by carbons. Amsterdam: Elsevier. p. 301-328.
Cantrell, K., Hunt, P.G., Uchimiya, M., Novak, J.M., and Ro, K.S. 2012. Impact of pyrolysis temperature and manure source on physicochemical characteristics of biochar. Bioresource Technology, 107:419-428.
Chun, Y., Sheng, G. Y., Chiou, C. T., and Xing, B. S. 2004. Compositions and sorptive properties of crop residue-derived chars. Environmental Science Technology, 38:4649–4655.
Claoston, N.A., Samsuri, M.H., and Husni, A. 2014. Effects of pyrolysis temperature on the physicochemical properties of empty fruit bunch and rice husk biochars. Waste Management & Research, 32(4): 331-339.
Enders, A., Hanley, K., Whitman, T., Joseph, S., and Lehmann, J. 2012. Characterization of biochars to evaluate recalcitrance and agronomic performance, Bioresource. Technol., 114, 644–653.
Ghani, W., A. Mohd, G. da Silva, R. Bachmann, Y. Taufiq-Yap, U. Rashid, and A. Al-Muhtaseb. 2013. Biochar production from waste rubber-woodsawdust and its potential use in C sequestration: Chemical and physical characterization,” Ind. Crop Prod., vol. 44, pp. 18-24.
Guo, J. and Chen, B. 2014., Insights on the molecular mechanism for the recalcitrance of biochar: interactive effects of carbon and silicon components. Environ. Sci. Technol. 48, 9103–9101.
Jia, Y., Shi, S., Liu, J., Su, S., Liang, Q., Zeng, X. and Li, T. 2018. Study of the effect of pyrolysis temperature on the Cd2+ adsorption characteristics of biochar, Applied Science 8(1019) 1-14.
Jindo, K., Mizumoto, H., Sawada, Y., Sanchez-Monedero M.A., and Sonoki, T. 2014. Physical and chemical characterization of biochars derived from different agricultural residues. Biogeosciences, 11:6613-6621.
Joseph, S., Downie, A., Munroe, P., Crosky, A., 2007. Biochar for carbon sequestration, reduction of greenhouse gas emissions and enhancement of soil fertility; A review of the materials science. Proceeding of the Australian Combustion Symposium. Emissions and Enhancement of Soil Fertility, pp:130-133.
Kim, K. H., Kim, J.Y., Cho, T.S., Choi, J. W. 2012. Influence of pyrolysis temperature on physicochemical properties of biochar obtained from the fast pyrolysis of pitch pine. Bioresource Technology, 118: 158-162.
Lee, Y., Park, J., Ryu, C., Gang, K.S., Yang, W., Park, Y-K., Jung, J., and Hyun, S. 2013. Comparison of biochar properties from biomass residues produced by slow pyrolysis at 500°C. Bioresource Technology, 148:196–201.
Lehmann, J., and Joseph, S. 2009. Biochar for Environmental Management: Science and Technology. Earthscan, London. 448pp.
Li, M. Liu, Q. Guo, L. Zhang, Y. Lou, Z. Wang, Y. and Qian, G. 2013. Cu(II) removal from aqueous solution by Spartina alterniflora derived biochar. Bioresource Technology 141, 83–88.
Liu, Z., and Han, G., 2015. Production of solid fuel biochar from waste biomass by law temperature pyrolysis. The Science and Technology of Fuel and Energy. pp:159-165.
Liu, Z., Niu, W., Chu, H., Zhou, T., and Niu, Z. 2018. Effect of the carbonization temperature on the properties of biochar produced from the pyrolysis of crop residues, Bioresource. 13(2), 3429-3446.
Luo, L., C. Xu, Z. Chen, and Zhang, S. 2015. Properties of biomass-derived biochars: Combined effects of operating conditions and biomass types, Bioresource Technology., vol. 192, pp. 83-89.
Mohan, D., Pittman, C.U., and Steele, P.H., 2006. Pyrolysis of wood/biomass for bio oil: a critical review. Energy and Fuels. 20:848-889.
Mukome, F. N. D., Zhang, X., Silva, L. C. R., Six, J., and Parikh, S. J.: Use of chemical and physical characteristics to investigate trends in biochar feedstocks, J. Agric. Food Chem., 61,2196–2204, 2013.
Pituello, C., Francioso, O., Simonetti, G., Pisi, A., Torreggiani, A., Berti, A., and Morari, F. 2015. Characterization of chemical–physical, structural and morphological properties of biochars from biowastes produced at different temperatures. J. Soils Sediments 15, 792–804.
Reeves, J.B. et al. Near infrared spectroscopic examination of charred pine wood, bark, cellulose and lignin: implications for the quantitative determination of charcoal in soils. Journal Near Infrared Spectroscopy, 15, p. 307-315, 2007.
Singh, B., Camps-Arbestain, M., and Lehmann, J. 2017. Biochar: A guide to analytical methods. CSIRO PUBLISHING. pp:310.
Singh, B., Singh, B.P., and Cowie, A. L. 2010. Characterisation and evaluation of biochars for their application as a soil amendment. Australian Journal of Soil Research. 48:516-525
Sun X., R. Shan, X. Li, J. Pan, X. Liu, R. Deng and Song, J. 2017. Characterization of 60 types of Chinese biomass waste and resultant biochars in terms of their candidacy for soil application. Bioenergy 9,1423-1435.
Suri, A. and Horio, M. 2010. Solid biomass combustion, in: Handbook of Combustion vol. 4, Solid Fuels, edited by: Lackner, M., Winter, F., and Agarwal, A. K., WILEY-VCH Verlag GmbH & Co. KGaA, Weinheim, chapter 3, 85–140.
Thangalazhy-Gopakumar S, Adhikari S, Ravindran H, Gupta RB, Fasina O, Tu M, and Fernando SD. 2010. Physiochemical properties of bio-oil produced at various temperatures from pine wood using an auger reactor. Bioresource Technology, 101(21):8389-95.
Tsai, W.T., Liu, S.L., Chen, H.R., Chang, Y.M., and Tsai, Y.L. 2012. Textural and chemical properties of swine-manure-derived biochar pertinent to its potential use as a soil amendment. Chemosphere, 89(2): 198-203.
Westerman, R.L. (ed.). 1990. Soil Testing and Plant Analysis: Third Edition. Number 3 in the Soil Science Society of America Book Series. Pp: 784. Soil Science Society of America, Inc., Madison, Wisconsin, USA.
Wu, W., Yang, M., Feng, Q., McGrouther, K., Wang, H., Lu, H. and Chen, Y. 2012. Chemical characterization of rice straw-derived biochar for soil amendment, Biomass Bioenergy., 47, 268–276.
Journal of Agricultural Science and Technology
Volume 22, Issue 2
March and April 2020
Pages 547-561