Volume 25, Issue 1 (2023)
JAST 2023, 25(1): 47-59 |
Back to browse issues page
Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:
Saygili Y S, Cakmak B. Improvement of Wear Resistance in Toothed Harrows Coated with HVOF and PVD Methods. JAST 2023; 25 (1) :47-59
URL: http://jast.modares.ac.ir/article-23-56920-en.html
URL: http://jast.modares.ac.ir/article-23-56920-en.html
1- Department of Biosystem Engineering, Faculty of Agricultural Sciences and Technologies, Niğde Ömer Halisdemir University, Niğde, Turkey. , serhatsaygili@ohu.edu.tr
2- Department of Agricultural Machinery and Technologies Engineering, Faculty of Agriculture, Ege University, İzmir, Turkey.
2- Department of Agricultural Machinery and Technologies Engineering, Faculty of Agriculture, Ege University, İzmir, Turkey.
Abstract: (1291 Views)
Surfaces of the toothed harrow were improved by using different coating materials and methods. Four different coating methods and special alloy powders were used as coating materials. TiCN was applied with PVD, and the WC-Ni-Co-Cr-Si-Fe-B powder mixture was applied with HVOF. The coating thicknesses was 2 µm and 5 µm in PVD, 500 µm in the HVOF, and 500+2 µm in the application where HVOF + PVD were used together. The wear trials were carried out in the laboratory, at a 50 km distance, in a double-speed trial pattern that converted circular motion to linear motion. The trial model was used to simulate the wear that occurs under real operating conditions in the soil. As a result of the wear trials carried out under the same operating conditions, a total material loss of 3.99 g occurred in the control (uncoated) harrow, the wear resistance increased, and less material loss was observed in the coated harrows. The sample coated with the PVD method had the lowest value with a material loss of 0.14 g. Material loss for other coated samples PVD-5µ, HVOF-500µ, and PVD-2µ+HVOF-500µ was 0.19, 0.28, and 0.18 g, respectively. When the amount of wear in the uncoated sample was 100%, the proportional loss in PVD-2µ, PVD-5µ, HVOF-500µ, and PVD-2µ+HVOF-500µ coated samples was calculated as 3.41, 4.85, 7.16, and 4.57%, respectively.
Article Type: Original Research |
Subject:
Agricultural Machinery/Mechanization
Received: 2021/11/4 | Accepted: 2022/01/29 | Published: 2023/01/6
Received: 2021/11/4 | Accepted: 2022/01/29 | Published: 2023/01/6
Send email to the article author
| Rights and permissions | |
 |
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License. |